Audi TT 2007 Repair Manual page 98

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
Plastic selector relay lever:
• To avoid damage to the selector cable, the control cable re‐
tainer must be disconnected from the selector cable before
removal.
– Pull the securing mechanism forward as far as the stop in the
direction of -arrow 1- and then unlock to the left in the direction
of -arrow 2-.
– Then press the selector relay lever forward (direction of
-arrow 3-).
• The control cable retainer may only be removed with the se‐
lector relay lever removed
– Remove the control cable mounting bracket from the trans‐
mission. Remove three bolts -arrows- for this purpose.
– Remove the driveshaft. Refer to ⇒ Rear Final Drive 02D, 0AV,
0BR and 0BY; Rep. Gr. 39 ; Removal and Installation
– Remove the fasteners -arrows- and remove the heat shield to
the back.
– Pivot shift housing downward and remove with shift cables.
Installing
Install in reverse order, paying attention to the following:
92
Rep. Gr.34 - Controls, Housing
⇒ page 69
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.