Audi TT 2007 Repair Manual page 139

– In the following step, ensure that the selector shaft is not
locked by the lock elbow -arrow-.
– Move shift shaft to neutral position.
– Remove mounting bolt -2-.
– Remove the bolts -3-.
– Remove back-up light switch -F4- -1-.
– Pull selector shaft -4- off transmission housing.
– Remove the left flange shaft bolt by installing 2 bolts in the
flange and counter holding the flange shaft with the assembly
lever.
– Remove bolts -B- inside clutch housing for securing clutch
housing to transmission housing.
Note
One bolt -arrow- is located outside of bolting flange.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Secure the input shaft by inserting the -VW 455- over the input
shaft, onto the clutch housing.
– Then tension separating tool -A-, for example -Kukko 17/0-
tightly behind input shaft splines.
• Back side of separating tool must contact pressing sleeve free
of play.
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly
Audi TT 2007 ➤
133