Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Position -10 - 222 A- on bolted fender flange with the following
tool components:
♦ Bracket for engine -10 - 222 A /1- , qty. 2
♦ Bracket with spindle and hook -10 - 222 A /10- (spindle faces
toward rear)
♦ Spindle -10 - 222 A /11- (spindle faces toward front)
♦ Shackle -10 - 222 A /12-
♦ Connectors -T40091/3- , qty. 2
– Engage -10 - 222 A /11- with -10 - 222 A /12- on right engine
lifting eye.
– Engage -10 - 222 A /10- on -T10338- .
– Lightly tension the engine/transmission assembly with the
spindles.
– Connect -T40093/3- (qty. 2) with left side -T40093/3-2- or right
side -T40093/3-3- .
– Disconnect ground (GND) cable from left longmember.
– Remove left and right connecting bolts for front part of long‐
member.
– Install -T40093/3-2- (left) and -T40093/3-3- (right) on the long‐
members with the previously removed bolts -arrow-.
Note
The left side of the vehicle is shown in the illustration.
– Insert -T40091/1- in -T40091/3- and -T40093/3- as shown in
illustration.
100
Rep. Gr.34 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.