Audi TT 2007 Repair Manual page 39

– Remove bolt -arrow A- and remove left front footwell vent -1-.
– Unclip wiring guide behind footwell vent -1- and lay aside.
– Remove impact bolster -2- secured with one or two bolts
-B arrows- depending on the version.
– Remove clutch pedal -1- from mounting bracket -3-, to do so
remove nut -2- and pull out bolt -5-.
– Swivel clutch pedal slightly downward and remove over-center
spring -4- from mounting bracket.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Disengage the mounting clip of the master cylinder actuator
with respect to the correctness of information in this document. Copyright by AUDI AG.
rod using the -T10005- .
– Remove clutch pedal.
Installing
• Tightening specification, refer to
⇒ "2.2 Pedal Assembly, Master Cylinder Assembly Overview
", page 17 .
Install in reverse order, paying attention to the following:
Note
Replace self-locking nut.
♦
Lubricate the various bearing and contact surfaces with
♦
grease -G 000 450 02- .
Manual Transmission - Edition 10.2009
4. Removal and Installation
Audi TT 2007 ➤
33