Audi TT 2007 Repair Manual page 147

– Tighten the bolts -3- for the shift cover -4-.
– Install lock bolt -2-, lock bolt -arrow- must not be installed when
doing so.
– Install back-up light switch -F4- -1-.
– Install left flange shaft. Refer to
⇒ "1.1 Flange Shaft and Seals on Transmission Assembly
Overview", page 219
– Drive in the input shaft sealing ring.
– Install the clutch slave cylinder with release bearing. Refer to
⇒ "4.7 Slave Cylinder with Release Bearing", page 39
– Shift through all gears.
– Drive cap into transmission housing to stop of -T10042-
Install bevel box in manual transmission as follows:
Caution
Risk of damaging sealing ring between transmission and bevel
box.
♦ Place bevel box on transmission together with right flange
shaft while turning shaft.
– With manual transmission, lubricate differential splines with
grease for clutch disc shaft splines -G 000 100- .
– Slide on bevel box completely on manual transmission, while
doing this, join splines of input shaft/bevel box centrally with
differential.
– With proper tooth position and central guiding, bevel box slips
up to stop against manual transmission.
Note
Do not pull bevel box with mounting bolts against manual trans‐
mission, otherwise bevel box is canted and mounting eyelets can
break off.
.
Manual Transmission - Edition 10.2009
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
5. Disassembly and Assembly
141