Audi TT 2007 Repair Manual page 151

– Remove the cap/input shaft circlip -A-.
– Knock rubber through in center of cap -C- using a screwdriver .
– Remove cap from transmission housing.
A - Support , for example -Kukko 22/1-
B - Internal puller 8 to 12 mm , for example -Kukko 21/01-
Remove circlip -C- from input shaft grooved ball bearing in the
following manner:
– Hold one end of circlip in place using screwdriver -A-.
– With the 2nd screwdriver -B-, pry the other end of the circlip
out of the groove of the grooved ball bearing -arrow-.
– By repositioning screwdriver -B-, pry the circlip out further.
– Remove mounting bolts -A- for transmission housing at clutch
housing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly
Audi TT 2007 ➤
145