Audi TT 2007 Repair Manual page 88

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
❑ Lock sleeve without shoulder, driving in
9 - Needle Bearing for Reverse Shaft
❑ Replace after each disassembly
❑ Pulling out ⇒ page 156
❑ Installing ⇒ page 156
10 - Taper Roller Bearing Outer Race
❑ For output shaft 5th/6th gear/reverse gear
❑ Removing and installing, refer to
❑ In the event of replacement: adjust the output shaft for 5th/6th gear/reverse gear, refer to
⇒ "2.5 Output Shaft for 5th/6th Gear and Reverse Gear, Adjusting", page 188
11 - Adjustment Shim
❑ For output shaft 5th/6th gear/reverse gear
❑ Adjustment overview, refer to
12 - Taper Roller Bearing Outer Race
❑ For output shaft for 1st to 4th gear
❑ Removing and installing, refer to
❑ In the event of replacement: adjust the output shaft for 1st to 4th gear, refer to
⇒ "2.3 Output Shaft, 1st to 4th Gears, Adjusting", page 183
13 - Adjustment Shim
❑ For output shaft for 1st to 4th gear
❑ Adjustment overview, refer to
14 - Taper Roller Bearing Outer Race
❑ for the differential
❑ Removing and installing, refer to
❑ When replacing: adjust the differential, refer to
15 - Adjustment Shim
❑ For the differential
❑ Adjustment overview, refer to
16 -
Bushing for Selector Shaft
❑ Pulling out ⇒ page 157
❑ Driving in ⇒ page 157
17 - Sealing Plug
❑ Driving out ⇒ page 157
❑ Driving in ⇒ page 157
18 - Left Flange Shaft Seal
❑ Replace, refer to
82
Rep. Gr.34 - Controls, Housing
⇒ page 156
⇒ "3.3 Output Shaft for 5th/6th Gear and Reverse Gear", page 202
⇒ "1.4 Adjustment Overview", page 224
⇒ "3.2 Output Shaft, 1st to 4th Gears", page 194
⇒ "1.4 Adjustment Overview", page 224
⇒ "1.3 Differential Assembly Overview", page 222
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "1.4 Adjustment Overview", page 224
⇒ "3.2 Left Flange Shaft Seal", page 228
⇒ "1.4 Adjustment Overview", page 224