Audi TT 2007 Repair Manual page 160

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Guide a screwdriver -A- into hole -B- of the lock elbow.
– Pry out lock elbow -arrow-.
Installation Position of Lock Elbow
• The marking on the lock elbow -arrow- must point to clutch
slave cylinder connection -1-.
• The angle -a- must be approximately 45°.
Drive in the Lock Elbow for the Selector Shaft.
• The lock elbow -arrow- must be released for the driving-in
procedure.
– Drive in the lock elbow to the tool stop.
Pulling Out Bearing Bushing for Selector Rod
A - Internal puller 14.5 to 18.5 mm , for example -Kukko 21/2-
B - Support , for example -Kukko 22/2-
Driving In Bushing for Selector Rod
154
Rep. Gr.34 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.