Audi TT 2007 Repair Manual page 157

– Drive the cap into the transmission housing as far as the stop.
– Secure the cap with the circlip -A-.
Install bevel box in manual transmission as follows:
Caution
Risk of damaging sealing ring between transmission and bevel
box.
♦ Place bevel box on transmission together with right flange
shaft while turning shaft.
– With manual transmission, lubricate differential splines with
grease for clutch disc shaft splines -G 000 100- .
– Slide on bevel box completely on manual transmission, while
doing this, join splines of input shaft/bevel box centrally with
differential.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Bring right drive axle splines and differential bevel gear also
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
into alignment, rotate flanged shaft if necessary.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– With proper tooth position and central guiding, bevel box slips
up to stop against manual transmission.
Note
Do not pull bevel box with mounting bolts against manual trans‐
mission, otherwise bevel box is canted and mounting eyelets can
break off.
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly
Audi TT 2007 ➤
151