Audi TT 2007 Repair Manual page 195

Adjustment overview, refer to
⇒ "1.4 Adjustment Overview", page 224
Special tools and workshop equipment required
♦ Dial Gauge Holder -VW 387-
♦ Punch -VW 407-
♦ Thrust Pad Con. 8/65 -VW 433-
♦ Installation Arbor -VW 792-
♦ Holding Fixture -VW 801-
♦ Thrust Plate -2050-
♦ Dial Gauge -VAS 6080-
♦ Kukko 21/7 internal puller
♦ Kukko 22/2 counter-support
Adjusting
• Transmission removed, refer to
⇒ "4.4 Transmission, Removing", page 96
assembly stand
⇒ "4.6 Transmission, Securing to Assembly Stand",
page 107 .
• Sealing surfaces of clutch- and transmission housing must be
cleaned of sealant.
• For the measurement, only install shaft to be measured.
– Press the tapered roller bearing outer ring with a 1.70 mm ad‐
justment shim into the transmission housing. Support trans‐
mission housing directly beneath bearing mount using -2050- .
– Set the complete output shaft for 5th/6th gear and reverse gear
into the clutch housing.
– Install transmission housing and tighten bolts -A- as well as
-B- to tightening specification in diagonal sequence.
and secured to the
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
2. Description and Operation
Audi TT 2007 ➤
189