Audi TT 2007 Repair Manual page 104

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Remove cable mounting bracket from transmission -arrows-
and tie it up off to the side with the cables.
– When a plastic line is installed between the clutch master and
slave cylinder, clamp off the return line to the clutch master
cylinder with -3094- .
Note
During the following procedures, make sure that brake fluid
♦
does not leak onto the starter or the transmission. If this hap‐
pens, these areas must be cleaned thoroughly.
To prevent dirt from entering, seal open lines and connections
♦
with clean plugs or protective caps.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– If a hose/line assembly is installed between the clutch master
and slave cylinder, clamp off hose -A- with -3094- .
Note
Pay no attention to -arrow-.
– Pull out the clip -arrow- to the stop.
– Remove the plastic line or hose/line assembly -A- from the
bleeder/clutch slave cylinder and seal it off.
Note
Disregard item -B-.
Caution
Clutch pedal must no longer be operated.
98
Rep. Gr.34 - Controls, Housing