Audi TT 2007 Repair Manual page 162

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
Drive In Lock Sleeve with Shoulder as Far as Stop on Tool
• Transmission housing fastened to clutch housing.
Drive In Lock Sleeve without Shoulder as Far as Stop on Tool
• Transmission housing fastened to clutch housing.
Pulling Needle Bearing for Reverse Shaft Out of Transmission
Housing
A - Internal puller 23.5 to 30 mm , for example -Kukko 21/4-
B - Support , for example -Kukko 22/2-
Note
Needle bearing is destroyed when it is removed and must be re‐
placed.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Press Needle Bearing into Transmission Housing
– During pressing sequence, place thrust washer -B- for reverse
shaft onto the needle bearing -A-.
– Support the transmission housing with the -VW 416 B- directly
under the bearing mount.
156
Rep. Gr.34 - Controls, Housing
with respect to the correctness of information in this document. Copyright by AUDI AG.