Audi TT 2007 Repair Manual page 145

– Align the marking on the grooved ball bearing -A- with the
marking on the transmission housing -B- and mount the trans‐
mission housing.
Continuation for all transmissions
– Heat the transmission housing using the hot air blower -V.A.G
1416- in the area of the bearing seat for the grooved ball bear‐
ing/input shaft to approximately 100 °C (212 °F) for approxi‐
mately 10 minutes.
Note
It is necessary to heat the transmission housing so that the
grooved ball bearing is not damaged when the housing is being
installed.
– Apply sealing paste -AMV 188 200 03- evenly onto the sealing
surface of the clutch housing.
– Install transmission housing and tighten new bolts -A-, -B- and
-C- to tightening specification.
Allocation of bolts:
A - Bolt with permanent washer
B - Bolt without washer
C - Bolt with permanent washer
– If a spacer washer was mounted on the grooved ball bearing
before installation of the transmission housing, a spacer wash‐
er -1- (outer diameter = 78.6 mm) must also be installed after
installation of transmission housing -2-. ⇒ page 137 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly
Audi TT 2007 ➤
139