Audi TT 2007 Repair Manual page 141

– Screw adapter -VW 771/40- into threaded hole of transmission
housing.
– Heat the transmission housing using the hot air blower -V.A.G
1416- in the area of the bearing seat for the grooved ball bear‐
ing/input shaft to approximately 100 °C (212 °F) for approxi‐
mately 10 minutes.
– Pull off transmission housing from clutch housing -arrow- us‐
ing -VW 771/1- .
Note
If necessary, carefully pry up all around and alternating between
sides on protruding flange taking care not to damage sealing sur‐
faces.
– If present, remove spacer washer -1- from grooved ball bear‐
ing -2-.
– If the transmission housing is replaced, check whether the
spacer washer needs to be reinstalled
– Remove separating tool -A- and -VW 455- from input shaft.
A 2nd technician is required to remove shafts from clutch housing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
⇒ page 137 .
Audi TT 2007 ➤
5. Disassembly and Assembly
135