Audi TT 2007 Repair Manual page 103

– With the ignition switched off, disconnect the battery ground
(GND) cable. Refer to ⇒ Electrical Equipment; Rep. Gr. 27 ;
Removal and Installation .
– Remove the entire air filter housing. Refer to ⇒ Fuel Injection
and Ignition; Rep. Gr. 24 ; Removal and Installation .
– Remove line -1- from air filter bracket -2-.
– Remove bolts -arrows- and remove air filter bracket.
– Remove the shift cable lock washer -3- from the transmission
shift lever -1- and remove the cable from the pins -arrow-.
– Remove lock washer -1- and remove the control cable retainer
from the pin.
Metal selector relay lever
– Remove lock washer -2- and remove the control cable retainer
from the selector relay lever.
Plastic selector relay lever
• To avoid damage to the selector cable, the control cable re‐
tainer must be disconnected from the selector cable before
removal.
– Pull the securing mechanism forward as far as the stop in the
direction of -arrow 1- and then unlock to the left in the direction
of -arrow 2-.
– Then press the selector relay lever forward (direction of
-arrow 3-).
• The control cable retainer may only be removed with the se‐
lector relay lever removed
All Vehicles
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 69
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation
97