Audi TT 2007 Repair Manual page 205

Assembling Locking Collar/Synchronizer Hub for 1st and 2nd
Gears as well as 3rd and 4th Gears
• The locking collar is pushed over the synchronizer hub.
– Insert locking pieces and install the springs 120° offset.
• Spring must engage with angled end into hollow engaging
piece.
Installation Position of Locking Collar/Synchronizer Hub for 1st
and 2nd Gear
• The identification groove -arrow 1- and thin collar -arrow 2- of
synchronizer hub point to 1st gear.
Pressing on locking Collar/Synchronizer Hub for 1st and 2nd Gear
– Then install circlip.
Installation Position of Outer Ring for 1st and 3rd Gear
• Tabs -arrows- point to synchronizer hub/locking collar -A-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
3. Disassembly and Assembly
Audi TT 2007 ➤
199