Audi TT 2007 Repair Manual page 143

– Fasten the bracket -30 - 211 A- for the input shaft to the clutch
housing.
Note
For the sake of illustration, clutch housing is depicted rotated
180°.
– Screw in bolt -A- far enough until input shaft rises slightly.
Note
With some transmissions, there are flattened areas -A- on the
♦
input shaft grooved ball bearing and on the bearing mount
-B-.
Check the input shaft grooved ball bearing and the transmis‐
♦
sion housing.
Input shaft grooved ball bearing and transmission housing
Without flattened areas on grooved ball bearing -A- and bearing
mount -B-
With flattened areas on grooved ball bearing -A- and bearing
mount -B-
From transmission build date 4.10.06 through approximately
1.21.08
One spacer washer is inserted above and below the input shaft
grooved ball bearing -6-
Upper spacer wash‐
er
Lower spacer wash‐
er
Measure the Shoulder above the Grooved Ball Bearing Mount.
Shoulder Above
Grooved Ball Bear‐
ing
Through transmis‐
sion build date 09 04
6
From transmission
build date 10 04 6
⇒ page 137
⇒ page 138
⇒ page 180 .
Outer circumfer‐
ence
Outer circumfer‐
ence
Dimension "a" Upper Spacer
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
10 mm
10.7 mm
Manual Transmission - Edition 10.2009
78.6 mm
85 mm
Washer
No
Yes
Audi TT 2007 ➤
5. Disassembly and Assembly
137