Audi TT 2007 Repair Manual page 101

– Remove lock washers -1- and -4- and remove the control ca‐
bles from the pins.
Vehicles from VIN 8J-7-013001
– Pry the shift and selector lever off of the pins.
All Vehicles
– Remove circlips -2 to 3- and remove shift cable and selector
cable from selector mechanism housing.
Release the cable retainer -A- for the selector and shift cables
-B- as follows:
– Push sleeve forward up to the stop -arrow 1-.
– Turn sleeve to the right up to the stop -arrow 2- so that it en‐
gages.
– Remove the cable retainers from the cables.
– Pull off the circlips -1- and -2-.
– Remove the control cable mounting bracket from the control
cables.
Installing
Install in reverse order, paying attention to the following:
– Secure the shift cable and selector cable to the selector mech‐
anism housing with the circlips -1 to 4-.
Vehicles from VIN 8J-7-013001
– Press the shift and selector lever onto the pins.
All Vehicles
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
4. Removal and Installation
Audi TT 2007 ➤
95