Audi TT 2007 Repair Manual page 76

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
♦ Connecting Pin -T10027 A-
Adjustment Requirements
• Operating and transfer elements of shift mechanism must be
in proper condition.
• Shift mechanism must move freely.
• The transmission, clutch and clutch mechanism must be in
proper condition.
• Transmission in neutral position.
Adjusting
– Open the ashtray.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Carefully pry trim from center console -arrows-. permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Lift trim up over shift knob.
– Move the shift lever in the neutral position toward the left into
the 1st/2nd gear shift gate.
– Lift the noise insulation plate.
– Guide the -T10027A- through hole -A- and into hole -B-.
Note
To improve clarity, the noise insulation is removed in the figure.
– Completely remove the air filter housing. Refer to ⇒ Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Removal and Installation .
70
Rep. Gr.34 - Controls, Housing