Audi TT 2007 Repair Manual page 99

– Insert the shift mechanism and tighten the nuts -arrows-. Tight‐
ening specification -16-
– Route the cables -1- from the shift mechanism -2- to the trans‐
mission as follows:
• The cables must run parallel to each other and must not in‐
tersect.
• The cables must be routed in the provided recesses in the heat
shield -3-.
Note
The enlargement shows the heat shield from above.
A clip -A- holds the cables and heat shield to each other in place.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 60 .
Manual Transmission - Edition 10.2009
4. Removal and Installation
Audi TT 2007 ➤
93