Audi TT 2007 Repair Manual page 190

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
• Sealing surfaces of clutch- and transmission housing must be
cleaned of sealant.
• For the measurement, only install shaft to be measured.
– Press the tapered roller bearing outer ring with a 1.70 mm ad‐
justment shim into the transmission housing. Support trans‐
mission housing directly beneath bearing mount using -2050- .
– Set complete output shaft for 1st to 4th gears into clutch hous‐
ing.
– Install transmission housing and tighten bolts -A- as well as
-B- to tightening specification in diagonal sequence.
184
Rep. Gr.35 - Gears, Shafts
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.