Audi TT 2007 Repair Manual page 95

Manual Transmission Mount on Engine
Item
2)
1 ,
3)
3
4)
2
4)
4 ,
4)5)
5
3)
6
A
• 1)
Replace bolts.
• 2)
Bolt with 8 mm threaded pin
• 3)
With permanent washer.
•
4)
Bolted from the engine side into the transmission.
•
5)
The securing clip must be inserted in the engine oil pan
Bevel Box Bracket -A- Tightening Specification and Sequence
– Tighten bolts in 4 stages as follows:
1. Install bolts -1- and -2- hand tight.
2. Pretighten bolts -1- to 3 Nm.
3. Tighten bolts -2- to 35 Nm.
4. Tighten bolts -1- to 45 Nm.
Right Drive Axle Heat Shield - Tightening Specification
– Tighten bolts -arrows- to 25 Nm.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1
Bolt
M12x55
M12x65
M12x55
M10x50
M12x80
Alignment sleeves for centering
Manual Transmission - Edition 10.2009
Nm
80
80
80
40
80
Audi TT 2007 ➤
89
3. Specifications