Audi TT 2007 Repair Manual page 140

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Knock rubber through in center of cap -C- using a screwdriver.
– Remove cap from transmission housing.
A - Support , for example -Kukko 22/1-
B - Internal puller 8 to 12 mm , for example -Kukko 21/01-
Remove circlip -C- from input shaft grooved ball bearing in the
following manner:
– Hold one end of circlip in place using screwdriver -A-.
– With the 2nd screwdriver -B-, pry the other end of the circlip
out of the groove of the grooved ball bearing -arrow-.
– By repositioning the screwdriver -B-, pry the circlip further out.
– If present, remove spacer washer -1- from transmission hous‐
ing -2-.
• If the transmission housing is replaced, check whether the
spacer washer needs to be reinstalled
– Remove bolts -A-.
134
Rep. Gr.34 - Controls, Housing
⇒ page 137 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.