Audi TT 2007 Repair Manual page 109

– Remove right drive axle heat shield from bevel box -arrows-.
– Remove the left drive axle from transmission flange shaft .
– Remove the right drive axle from the bevel box flange shaft .
– Raise drive axles and secure with cable ties.
Note
Make sure drive axle protective coating is not damaged.
– Remove the bolts -arrows- and remove the bevel box bracket.
– Identify position of flexible disc and bevel box flange to each
other.
– Remove driveshaft flexible disc from bevel box -arrows- while
counterholding at triangular flange with a lever.
– Press engine/transmission assembly slightly forward (toward
front end) and pull off driveshaft from bevel box.
Caution
Risk of damaging sealing ring -arrow- in driveshaft flange.
♦ Press driveshaft horizontally as far back and to the right
side of the vehicle as possible.
Note
If seal is damaged, driveshaft must be replaced.
– Tie driveshaft up.
Manual Transmission - Edition 10.2009
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
4. Removal and Installation
103