Audi TT 2007 Repair Manual page 154

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Insert differential -1-.
Note
A 2nd technician is required for further installation of shafts into
clutch housing.
– As shown in illustration, take output shaft for 1st to 4th gears
-3- with selector rods -4- in right hand.
– Lift differential slightly with the left hand.
– At the same time, 2nd technician slightly lifts input shaft, output
shaft for 5th/6th gears and reverse gear -2- together with re‐
verse shaft.
– Now, insert the output shaft for 1st to 4th gears in direction of
-arrow-.
• Places of input shaft, output shafts and final drive gear/differ‐
ential must engage.
– Together with a 2nd technician, place the shafts and the dif‐
ferential into their bearing seats.
– Fasten the -30-211A- for the input shaft to the clutch housing.
Note
For the sake of illustration, clutch housing is depicted rotated
180°.
– Screw in bolt -A- far enough until input shaft rises slightly.
• The grooved ball bearing/input shaft only fits in one position in
the transmission housing.
There is a flattened area on the grooved ball bearing and the
bearing mount.
• If flattened areas -A- and -B- are present, do not insert any
spacer washers above and below the grooved ball bearing.
Refer to ⇒ "1.1 Grooved Ball Bearing Changes", page 177
• Flattened areas -A- on the grooved ball bearing and on bearing
mount -B- must align in the transmission housing.
– Mark the flattened areas with color.
– Place a marking on the upper area of the grooved ball bearing
and on the upper area of the transmission housing bearing
mount (⇒ next illustration).
– Heat the transmission housing using the -V.A.G 1416- in the
area of the bearing seat for the grooved ball bearing/input shaft
to approximately 100 °C (212° F) for approximately 10 mi‐
nutes.
148
Rep. Gr.34 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.