Audi TT 2007 Repair Manual page 241

– Place the bevel box on the hole -arrow- marked with the num‐
ber 4 in the -T10108- while laying the M12 x 10 nut -A- between
the bevel box and the transmission holder.
– Then align the bevel box with the remaining 3 holes and secure
it with the nut -A-.
– Place the -V.A.G 1782- underneath.
– Drain the axle oil from the bevel box.
– Bevel box output shaft with -T10108/1- , install the 2 M10 x 30
bolts -arrows-.
– Remove the output flange nut.
A - Wrench socket 36 mm
– Pivot bevel box so that output shaft faces upward.
– Remove the output flange form the bevel box shaft bevel gear.
A - Kukko 45/2 three arm puller
Note
When removing output shaft, inner race/tapered roller bearing re‐
mains on output shaft and must be removed from it .
– Place the -40 - 105- on the output flange.
– Remove the inner race of the tapered roller bearing from the
output flange using -V.A.G 1582- and -V.A.G 1582/6A- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3
/ 4 " drive
Manual Transmission - Edition 10.2009
3. Removal and Installation
Audi TT 2007 ➤
235