How To Control Ptz - Honeywell CADVR-1004-WD-M User Manual

4.8 How to control PTZ

【Zoom】Lens in the current play far closer picture, use the mouse wheel also can undertake variable times control.
【Focus】Slight adjusting the focal length
【Iris】Aperture size adjustment
【Speed】Through the slider adjust rotation step interval, PTZ mainly used to control direction operation, the step
length of turning the faster PTZ
【Preset】Adjust the camera Angle, then direction and the corresponding input and clicking on [ setup] button, preset
dots to set the dots in the preset rastelli.
Input presets dots and click on [Transfer] button, the camera will be transferred to the preset point corresponding
position.Click[clear ] button, this presets dianjiang be cleared
【Setup】Click 【Pattern Start】 the trajectory of said no corresponding, click the 【 Add Preset 】 and 【 Delete
Preset】, 【Clear Tour】 the cruise lines.
【Pattern Start】 begin to track record, was registered date 【 Pattern Stop】 ， thus set up from the corresponding track
circuit.
【Left Limit】Began to limit scanning Settings, was registered date 【 right Limit 】, thus set up corresponding limit
scanning.
【Add Preset】Add presets point to the cruise lines.
25