Ppp Ip Settings Reserved For Modem Connection; Setting An External Modem; Ptz Serial Device; Table 8-5 Names Of Temporary Tcp/Ip Addresses, For Ppp - Honeywell Rapid Eye Administrator's Manual

Configuring Other Hardware

PPP IP Settings Reserved for Modem Connection

Setting an External Modem

PTZ Serial Device

154
During a dial-up connection, temporary network communications are established between
the Rapid Eye site and the PC. A Host IP address for the Multi-Media unit is auto-detected
by the Microsoft Dial-Up Networking application. Different terms are used to describe these
communication points. To avoid confusion, these terms are listed in
Table 8-5 Names of Temporary TCP/IP Addresses, for PPP
a
Address Internal Port
172.26.200.1 PPP: client IP
172.26.2.1 PPP: host IP
a
This is not the Multi-Media unit network addressed as discussed in
Maintenance Session
The default, point-to-point protocol (PPP) IP settings can be changed, in the unlikely event
that they conflict with another network device (printer, scanner, and so on).
1. Consult the installer to find out which port on the unit is connected to the external
modem.
2. Continue or start a Maintenance Session
Devices tab.
3. Click the Internal Port - Modem icon. Boxes appear in the right half of the Serial
Devices tab (Baud Rate, Wait for Connection, and so on).
4. Change the values to those suggested by the external modem's documentation.
5. Drag the modem icon to the port icon with the number of the port identified in
A PTZ serial device is only used to control cameras that pan, tilt and zoom (PTZ). A Multi
SA obtains the Multi-Media unit's port number that is used for PTZ functions from the
installers of a Multi-Media system or by taking note of the back panel of the unit.
PTZ Device Settings
A PTZ device is set using a
PTZ settings on the Video tab. See
Description
At operator PC
At Multi-Media unit
on page 147.
for the Rapid Eye site. Click the Serial
Maintenance Session, on the Serial Devices tab. It enables the
Pan, Tilt, and Zoom (PTZ) Setup
Table 8-5.
Installation Shell
host
local
System Tab in a
step 1.
on page 95.