•
Current resolution and refresh rate
•
Device serial number and article number
•
Current firmware version and model name
•
Current illumination (in percentage)
•
Lamp runtime in hours
•
Chosen communication method and IP address (if connected)
•
Warp status
•
Environmental temperature
Starting image projection
1.
Make sure the available sources are connected to the appropriate input ports.
Tip: If properly connected, the "SYNC" LED will lit up ORANGE.
2.
Press the Input Selection button on the keypad or on the remote control until:
•
the LED of the selected source (the "SEL" LED) lit up GREEN, and
•
the image of the selected source is projected.
1
Image 8–3
8.2 Switching to standby
How to switch to standby
1.
Press and hold the Power on/off button for 3 seconds on the local keypad, or press the Power Off button
on the remote control.
The projector goes to standby mode. The after-cooling cycle will start (up to 300 seconds). During this
period the Power on/off button will blink. Once the after-cooling cycle has ended, the projector will be in
standby mode and the Power on/off button will be lit WHITE.
3 s
Image 8–4
2
300 s
Getting Started
R5906070 /16
HDX 4K
87