Mitel 6800i Series Administrator's Manual page 58

Mitel 6800i Series SIP Phone Release 4.1.0 Administrator Guide
Operation
The Operation section provides the following options:
HEADING
User Password
Phone Lock
Softkeys and XML
Programmable Keys
Expansion Module <N>
Keypad Speed Dial
Directory
Reset
2-10
DESCRIPTION
Allows you to change user password.
(Applicable to User and Administrator)
Allows you to assign an emergency dial plan to the phone, lock the
phone to prevent any changes to the phone and to prevent use of the
phone, and reset the user password.
Note: You can also configure a softkey to use for locking/unlocking the
phone.
(Applicable to User and Administrator)
6867i - 6 Top, multi-functional, static softkeys / 4 Bottom, state-based,
multi-functional softkeys
6869i - 12 Top, multi-functional, static softkeys / 5 Bottom, state-based,
multi-functional softkeys
(Applicable to User and Administrator)
6863i - 3 multi-functional, programmable keys
6865i - 8 multi-functional, programmable keys
(Applicable to User and Administrator)
The M680i has up to 16 configurable keys. The M685i has up to 84
configurable keys. You can have up to 3 expansion modules attached to
a single phone allowing you to configure keys for Expansion Module 1,
Expansion Module 2, and Expansion Module 3. See your
<Model-Specific> IP Phone User Guide for applicable expansion
modules for your model phone.
Note: M680i and M685i Expansion Modules apply to the 6865i, 6867i,
and 6869i only.
(Applicable to User and Administrator)
Allows you to configure up to 9 speeddial keys. These fields map to the
keypad digits 1 through 9 on the phone. You can also configure
additional speeddials on the programmable keys, softkeys and
expansion modules. See your <Model-Specific> IP Phone User Guide
for more information about this feature.
(Applicable to User and Administrator)
Allows you to copy the Callers List and Local Directory List from your IP
phone to your PC.
(Applicable to User and Administrator)
Allows you to restart the IP phone when required. (Applicable to User
and Administrator).
This setting also allows you to set the IP phone back to its factory default
settings or remove the local configuration. (Applicable Administrator
only)