Mitel 6800i Series Administrator's Manual page 189

MITEL WEB UI
1. Click on Advanced Settings->Network->Type of Service DSCP.
2. Select a Protocol field:
"SIP"
or
"RTP"
or
"RTCP"
3. Enter a value from 0 to 63. Default values are as follows:
• SIP = 26
• RTP = 46
• RTCP = 46
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled,
you will need to map the applicable priority to the Protocol setting as shown in the
first table in
information, see the section
4. Click Save Settings to save your settings.
Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
Note: VLAN is disabled by default. When you enable VLAN, the IP phones use the
default settings for each VLAN parameter. You can change the default settings if required
using the following procedure.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Virtual Local Area Network (VLAN) Settings"
"DSCP Range/VLAN Priority Mapping"
"Configuring VLAN (optional)"
on
on page 4-39.
on
page A-35.
Network Settings
For more
page 4-42.
4-42