Mitel 6800i Series Administrator's Manual page 879

Softkey/Programmable Key/Keypad Key/Expansion Module Key/Hard Key Parameters
PARAMETER –
softkeyN states
DESCRIPTION
FORMAT
DEFAULT VALUE
RANGE
EXAMPLE
CONFIGURATION FILES
startup.cfg, <model>.cfg, <mac>.cfg
Displays the status of the phone when a softkey is pressed. You can
enter multiple values (idle, connected, incoming, outgoing, busy)
for the "softkeyN state" parameter.
You must associate the softkeyN state parameter with a specific
softkey. In the following example, the softkeyN states parameter is
associated with softkey 12:
softkey12 type: speeddial
softkey12 label: voicemail
softkey12 value *89
softkey12 states: outgoing
Note: The IP phone idle screen condenses the softkeys. So in the
previous example, softkey 12 will appear in position 1 if no other
softkeys are set. A softkey type of "empty" does not display on the
idle screen at all.
Text
For softkey type none, flash, phonelock, paging: All states disabled
For softkey types dnd, speeddial, xml, lcr, callforward, speeddialxfer,
speeddialconf, directory, filter, callers, redial, conf, xfer, icom, empty:
idle, connected, incoming, outgoing, busy
For softkey type flash: All states disabled
For softkey type park, spre: connected
For softkey type pickup: idle, outgoing
Valid values are:
idle: The phone is not being used.
connected: The line currently being displayed is in an active call (or
the call is on hold)
incoming: The phone is ringing.
outgoing: The user is dialing a number, or the far-end is ringing.
busy: The current line is busy because the line is in use or the line
is set as "Do Not Disturb".
Note: For softkey type, Pickup, values can be: just idle, just outgoing,
or idle outgoing.
softkey1 states: idle incoming outgoing
softkey2 states: connected
A-220