Mitel 6800i Series Administrator's Manual page 188

Mitel 6800i Series SIP Phone Release 4.1.0 Administrator Guide
or
Select Type of Service RTCP.
6. Enter a value for "Type of Service SIP". Default is 26.
or
Enter a value for "Type of Service RTP". Default is 46.
or
Enter a value for "Type of Service RTCP". Default is 46.
Valid values are 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled,
you will need to map the applicable priority to the Protocol setting as shown in the
first table in
information, see the section
7. Press Done (3 times) to save the changes.
Note: The session prompts you to restart the IP phone to apply the configuration settings
8. Select Restart.
For the 6867i/6869i:
1. Press
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is "22222".
4. Select Network > DSCP.
5. Enter a value for "Type of Service SIP". Default is 26.
or
Enter a value for "Type of Service RTP". Default is 46.
or
Enter a value for "Type of Service RTCP". Default is 46.
Valid values are 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled,
you will need to map the applicable priority to the Protocol setting as shown in the
first table in
information, see the section
6. Press the Save softkey.
7. Restart the phone for the selection to take affect.
4-41
"DSCP Range/VLAN Priority Mapping"
"Configuring VLAN (optional)"
on the phone to enter the Options List.
"DSCP Range/VLAN Priority Mapping"
"Configuring VLAN (optional)"
on page 4-39 For more
on page 4-42.
on page 4-39 For more
on page 4-42.