Mitel 6800i Series Administrator's Manual page 502

Mitel 6800i Series SIP Phone Release 4.1.0 Administrator Guide
CONFIGURING VOICEMAIL
You configure Voicemail in the configuration files to dial a specific number to access an existing
voicemail account. The user then follows the voicemail instructions for listening to voicemails.
Note: The phone must have a registered voicemail account from a server for this feature
to be enabled. When no registered voicemail accounts are registered to the phone, the
display shows "List Empty".
To configure the Voicemail feature on the IP phone, you must enter the following parameter in
the configuration files:
• sip lineN vmail
You can enter a Voicemail number for each line on the phone.
For example:
sip line1 vmail: *97
sip line2 vmail: *95
Note: In the above example, the user would dial *97 to access the voicemail account
for line 1, and *95 to access the voicemail account for line 2.
Use the following procedure to configure voicemail using the configuration files.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Voicemail Settings"
Note: You can also access your Voicemail via the "Services" Key on your phone if this
has been setup by your System Administrator.
5-256
on .
page A-123