Mitel 6800i Series Administrator's Manual page 781

PER-LINE SETTINGS
PARAMETER –
sip lineN autodial number
(where N = line number)
DESCRIPTION
FORMAT
DEFAULT VALUE
RANGE
EXAMPLE
PARAMETER –
sip lineN autodial timeout
(where N = line number)
DESCRIPTION
FORMAT
DEFAULT VALUE
RANGE
EXAMPLE
Operational, Basic, and Advanced Parameters
CONFIGURATION FILES
startup.cfg, <model>.cfg, <mac>.cfg
On a per-line basis, this parameter specifies the SIP phone number
that the IP phone autodials when the handset is lifted from the phone
cradle. Valid values can be:
• -1 (Default): The phone uses the global autodial setting for this
line.
• Blank (Empty field): Disables autodial on this line.
• Valid SIP Number: Dials the SIP number specified for this line.
Integer
-1
Any valid SIP number.
sip line1 autodial number: 8500
CONFIGURATION FILES
startup.cfg, <model>.cfg, <mac>.cfg
On a per-line basis, this parameter specifies the time, in seconds,
that the phone waits to dial a pre-configured number after the
handset is lifted from the IP phone cradle.
If this parameter is set to 0 (hotline), the phone immediately dials a
pre-configured number when you lift the handset. If this parameter is
set to a value greater than 0, the phone waits the specified number
of seconds before dialing the pre-configured number (warmline)
when you lift the handset.
Default is 0 (hotline).
Integer
0
0-120
sip line1 autodial timeout: 30
A-122