Mitel 6800i Series Administrator's Manual page 377

Hide thumbs Also See for 6800i Series:

Table of Contents

*The M680i expansion module consists of 16 softkeys. You can have up to 3 expansion modules

on an IP phone totalling 48 softkeys. Valid for 6865i, 6867i, and 6869i phones.

**The M685i expansion module consists of 3 pages of 28 softkeys (for a total of 84). You can

have up to 3 expansion modules on an IP phone totalling 252 softkeys. Valid for 6865i, 6867i,

and 6869i phones.

STATE-BASED SOFTKEYS (BOTTOM SOFTKEYS ONLY)

Users and administrators can configure a specific state to display when a softkey is being used.

Available states you can configure for each softkey include:

idle - The phone is not being used.

connected - The current line is in an active call (or the call is on hold)

incoming - The phone is ringing.

outgoing - The user is dialing a number, or the far-end is ringing.

busy - The current line is busy because the line is in use or the line is set as "Do Not Disturb".

The following table identifies the applicable default states for each type of softkey you can

configure on the IP phone. Availability of the types is dependent on your IP phone model.

SOFTKEY TYPE

Last Call Return

Call Forward

Speeddial/Xfer

Speeddial/Conf

Troubleshooting