Mitel 6800i Series Administrator's Manual page 371

4. Enable the "Play a Ring Splash" feature by selecting either Enabled (when idle) or Enabled
also in call (when idle and in an active call state.
(Default is disabled).
5. If the "Play a Ring Splash" parameter is enabled, the IP phone plays a short "ring splash"
when there is an incoming call on the BLF monitored extension.
Note: This global setting is not dynamic. Changes to this setting will take effect only
after the phone has been rebooted.
6. Click Save Settings to save your changes.
CONFIGURING BLF OR BLF/LIST FOR DIRECTED CALL PICKUP
Use the following procedure to configure BLF or BLF/List for Directed Call Pickup in the
configuration files.
Note: You must enable Directed Call Pickup before performing these procedures. See
"Enabling/Disabling Directed Call Pickup"
CONFIGURATION FILES
To set BLF or BLF/List in the configuration files for Directed Call Pickup, see Appendix A, the
sections:
•
"Softkey/Programmable Key/Keypad Key/Expansion Module Key/Hard Key Parameters"
.
page A-213
•
"BLF List URI Settings"
Use the following procedure to configure BLF or BLF/List for Directed Call Pickup in the Mitel
Web UI.
MITEL WEB UI
1. Click on Basic Settings->Preferences->Directed Call Pickup Settings.
2. Enable the "Directed Call Pickup" field by checking the check box.
3. (optional) Enter a prefix in the "Directed Call Pickup Prefix" field. For example, *98.
This prefix is appended to the beginning of the Directed Call Pickup number when dialed
from the BLF or BLF/List softkey.
4. Enable the "Play a Ring Splash" feature by selecting either Enabled (when idle) or Enabled
also in call (when idle and in an active call state. (Default is disabled).
on .
page A-252
Operational Features
on page 5-124
on
5-125