IBM pSeries 690 Service Manual page 562

Error Code Description
4067 0EB9 Attention line 8 stuck fault
4067 0EBA Attention line 9 stuck fault
4067 0EBB Attention line 10 stuck fault
4067 0EBC Attention line 11 stuck fault
4067 0EBF Memory error
4067 0EE1 Bus tests detected fault in service processor
code (invalid MRU to mapping)
4067 0EE2 Bus tests detected fault in service processor
firmware fault
4067 0EE5 Bus tests detected firmware error; no callout
available
4067 25E6 SMA 4-port switch adapter fault
4067 273F SMA 2-port switch adapter fault
4068 0001 Other bus tests detected clock card assembly
failure
4068 0002 Other bus tests detected backplane assembly
failure
4068 0003 Other bus tests detected fault in MCM module
0
4068 0004 Other bus tests detected fault in MCM module
2
4068 0005 Other bus tests detected fault in MCM module
1
4068 0006 Other bus tests detected fault in MCM module
3
542 Eserver pSeries 690 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 391.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.
Go to "MAP 1540: Problem Isolation
Procedures" on page 298.
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
MCM module 1 and VPD card
Location: U1.18-P1-C3 and U1.18-P1-H2.5
MCM module 3 and VPD card
Location: U1.18-P1-C2 and U1.18-P1-H2.6