IBM pSeries 690 Service Manual page 404

Hide thumbs Also See for pSeries 690:

Table of Contents

Table 2. Firmware Checkpoints (continued)

Eserver pSeries 690 Service Guide

End of low-level firmware

Get the system's licensed memory quantity

from the service processor

SSA PCI adapter open firmware has run

successfully.

SSA PCI adapter BIST has started but

failed to complete after 4 seconds.

SSA PCI open firmware has started.

SSA PCI adapter BIST has completed with

SSA PCI adapter BIST and subsequent

POSTs have completed successfully.

SSA PCI adapter BIST has completed

successfully but subsequent POSTS have

SSA PCI open firmware about to exit (no

stack corruption).

SSA PCI open firmware has run

unsuccessfully.

SSA PCI open firmware about to exit (with

stack corruption).

Create system firmware VPD

Create memory VPD.

Create processor card VPD.

Create operator panel VPD.

Create processor subsystem VPD.

Create clock card VPD.

Create RIO extender card VPD.

Possible Failing FRU

1. Replace the I/O drawer subsystem

backplane specified by the location

2. Power down, then power up the system

using the UEPO switch.

3. Call service support.

1. Disconnect and then reconnect AC

power to the system using the UEPO

2. Verify that the CUoD capacity card is

installed and properly seated.

3. Call service support.

Replace the adapter.

System firmware may be corrupted.

Reinstall system firmware.