Step 1422-2
Is the PCI slot power LED of the location recorded in "Step 1422-1" on page 187 on?
NO
Go to "Step 1422-3".
YES
Go to "Step 1422-7".
Step 1422-3
Disconnect any external cables from the adapter identified in "Step 1422-1" on page 187.
Step 1422-4
Remove the adapter identified in "Step 1422-1" on page 187.
Step 1422-5
Follow the procedure "Installing a New Hot-Pluggable PCI Adapter" on page 906 to add a new adapter at
the location recorded in "Step 1422-1" on page 187. The new adapter should be the same type as that
removed in "Step 1422-1" on page 187. Return to "Step 1422-6" after the new adapter is added.
Step 1422-6
Did the PCI hot-plug procedure successfully add a new adapter at the location recorded in "Step
1422-1" on page 187?
NO
Go to "Step 1422-7".
Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information
YES
for Multiple Bus Systems. This ends the procedure.
Step 1422-7
Shut down the partition that the faulty slot is assigned to.
Step 1422-8
Is the PCI slot power LED of the location recorded in "Step 1422-1" on page 187 on?
NO
Go to "Step 1422-9".
YES
Go to "Step 1422-14" on page 189
Step 1422-9
Are there any empty PCI slots attached to the system that are not assigned to any partitions?
NO
Go to "Step 1422-14" on page 189.
YES
Go to "Step 1422-10".
Step 1422-10
Assign the available empty and unassigned slot to the partition that the faulty slot is assigned to.
188
Eserver pSeries 690 Service Guide