IBM pSeries 690 Service Manual page 988

then, power on through either the HMC commands or by physically toggling the power switch on the
node. Proceed to step 14 to verify the code has loaded.
5. For a 7026 or a 7040 with a SP Switch2 PCI adapter, do the following:
Efence -p x nn
(where x is plane number 0 or 1 and nn is the node_number of the server or logical partition)
RESPONSE: All nodes successfully fenced.
6. On the object server or logical partition (or with the dsh command), type:
/usr/lpp/ssp/css/ifconfig css0 down detach
Note: In a dual-plane environment, this could be performed on css0, css1 or both.
RESPONSE: driver unconfig OK
RESPONSE: driver unloaded
7. On the object server or logical partition (or with the dsh command), type:
stopsrc -s hats
RESPONSE: 0513-044 The hats subsystem was requested to stop
8. stopsrc -s hags
RESPONSE: 0513-044 The hags subsystem was requested to stop
9. 7) /usr/lpp/ssp/css/css_cdn
Note: This will kill the fault_service_Worm_RTG_SP process on the server or logical partition.
10. /usr/lpp/ssp/css/ucfgcor -l css0 (or css1)
11. Determine if the SP Switch2 PCI Attachment Adapter (css0 or css1) is running any processes using
the following command: fuser /dev/css0 and/or fuser /dev/css1. Kill any processes that are bound
to the adapter.
12. Run the following commands to remove power to the slot into which the adapter is plugged. This
action is necessary to activate the Xilinx update.
echo | /usr/sbin/drslot -R -c pci -l css0 -I
* echo | /usr/sbin/drslot -R -c pci -l css1 -I
If the previous command is run using dsh from the CWS, quotation marks are required around the
entire command as follows:
dsh "echo | /usr/sbin/drslot -R -c pci -l css0 -I"
13. Reboot the server or logical partition. Type:
shutdown -Fr
14. When the server or logical partition is back up, from the CWS, type:
Eunfence -p x nn
(where x is plane 0 or 1 and nn is the node_number of the server or logical partition)
RESPONSE: All nodes successfully unfenced.
968 Eserver pSeries 690 Service Guide