IBM pSeries 690 Service Manual page 932

2. Position the bezel and linkage subassembly with the bezel to the left, on a flat ESD surface.
3. Pivot the bezel so that the lower end is away from the linkage sub-assembly.
Note: Ensure that the top front clip is in the uppermost position before continuing.
a. If the adapter card is full-height (that is, taller than the tailstock of the card), do the following:
1) Place the top corner of the PCI card so that it seats in the top front clip, as shown in the
following diagram:
1 Cassette Top Linkage Bracket
2 Top Front Clip
3 Long Adapter
2) Rotate the bottom of the tailstock to fit in the front heel clip.
3) To remove any slack in the fit, use pliers or screwdriver to adjust the top front clip downward.
b. If the adapter card is not full-height (that is, shorter than the tailstock of the card), do the
following:
1) Place the bottom corner of the PCI card on the front heel clip.
2) To remove any slack between the top and bottom clips, use pliers or screwdriver to adjust the
top front clip downward. If the top clip is pushed too far down without engaging the card,
remove the top front clip by popping it off the rail. Reattach the clip and start again.
912 Eserver pSeries 690 Service Guide
4 Front Heel Clip
5 Adapter Cassette Bezel