11.
Snap the top-right corner of the cover over the guide bump on the linkage assembly.
12. Align the holes at the top of the cover with those in the linkage subassembly and screw the cover to
the linkage subassembly in the sequence shown in the following illustration.
5
13. Snap the tailstock clip onto the tailstock by rotating it onto the bracket while inside the bezel opening.
14. Raise the lever to the horizontal extended position and snap the tailstock clip onto the tailstock tab as
follows.
15. Visually inspect the assembly and ensure that the following are correct:
v The card moves up and down correctly when the handle is raised and lowered.
v The tailstock clip rides within the bezel opening.
2 Front Bottom Tab
2
3
4
Chapter 9. Removal and Replacement Procedures
1
917