IBM pSeries 690 Service Manual page 486

Error Code Description
20D1 0003 Failed to send boot status in LPAR partition
20D1 0004 Failed to locate service processor device tree
node
20D1 0005 Failed to reboot system in LPAR mode
20D1 0006 Failed to reboot a partition in LPAR mode
20D1 0007 Failed to set PCI read/write permissions array 1. Check for system firmware updates. Apply
20D1 0008 Failed to set PCI read/write permissions array
for slot
20D1 0009 Missing or invalid subsystem serial number
20D1 000A Failed to send boot failed message to service
processor
20D1 000B Failed to reset PCI read/write permissions
array
20D1 000C Failed to send LMB-TABLE-INFO mailbox
repair
466 Eserver pSeries 690 Service Guide
Action/
Possible Failing FRU
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. If a location code is shown with this error
code, replace the part at that location.
3. Contact your next level of support for
assistance.
Note: The location code identifies the failing
subsystem.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.