IBM pSeries 690 Service Manual page 289

Step 152j-15
Remove the following adapter cards, if present, from the I/O subsystem. Record the adapter locations:
v Adapter card at P1-I6
v Adapter card at P1-I7
v Adapter card at P1-I8
v Adapter card at P1-I9
v Adapter card at P1-I10
Step 152j-16
Turn on the power.
Step 152j-17
Did the system stop with the same error code as recorded in "Step 152j-1" on page 267?
Yes Go to "Step 152j-23" on page 270.
No Go to "Step 152j-18".
Step 152j-18
One of the cards just removed is defective.
Turn off the power.
Make sure all the green "power good out" LEDs of both I/O subsystem DCAs are off.
Step 152j-19
Reinsert one of the cards that is removed and listed in "Step 152j-15".
Step 152j-20
Turn on the power.
Step 152j-21
Did the system stop with the same error code as recorded in "Step 152j-1" on page 267?
Yes The card just reinserted is defective. Replace it.This ends the procedure.
Return the system to its original configuration.
Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information
for Multiple Bus Systems.
No Go to "Step 152j-22" on page 270.
Chapter 3. Maintenance Analysis Procedures
269