IBM pSeries 690 Service Manual page 332

Step 1542-9
Are there any adapters in slots 1, 2, 3, 4 or 5 (location codes Ux.y-P1-I1 through I5) on the left side
of the I/O subsystem?
NO Go to "Step 1542-10".
YES Go to "Step 1542-13".
Step 1542-10
Are there any adapters in slots 6, 7, 8, 9 or 10 (location codes Ux.y-P1-I6 through I10) on the left
side of the I/O subsystem?
NO Go to "Step 1542-11".
YES Go to "Step 1542-14" on page 313.
Step 1542-11
Are there any adapters in slots 1, 2, 3, 4 or 5 (location codes Ux.y-P2-I1 through I5) on the right
side of the I/O subsystem?
NO Go to "Step 1542-12".
YES Go to "Step 1542-15" on page 313.
Step 1542-12
Are there any adapters in slots 6, 7, 8, 9 or 10 (location codes Ux.y-P2-I7 through I10) on the right
side of the I/O subsystem?
NO Go to "Step 1542-19" on page 316.
YES Go to "Step 1542-16" on page 314.
Step 1542-13
1. If it is not already off, turn off the power.
2. Remove all adapters from slots 1, 2, 3, 4 and 5 (location codes Ux.y-P1-I1 through I5) from the left
side of the I/O subsystem that are not attached to the boot device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power to boot standalone diagnostics from CD.
6. If the TTY screen displays Enter 0 to select this console, press the 0 key on the TTY terminal's
keyboard.
7. If the Please define the System Console screen is displayed, follow directions to select the system
console.
8. Use the Display Configuration and Resource List to list all attached devices and adapters (refer to the
RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus Systems, order number
SA38-0509, if necessary).
9. Check that all attached devices and adapters are listed.
Did the Please define the System Console screen display and are all attached devices and adapters
listed?
NO Go to "Step 1542-10".
YES Go to "Step 1542-17" on page 314.
312 Eserver pSeries 690 Service Guide