IBM pSeries 690 Service Manual page 402

Table 2. Firmware Checkpoints (continued)
Checkpoint
E58D
E58E
E58F
E590
E591
E592
E593
E594
E595
382 Eserver pSeries 690 Service Guide
Description
Set up EADS function registers
Set up EADS function registers
Set up EADS function registers
Set up EADS function registers
Set up EADS function registers
Set up EADS function registers
Set up EADS function registers
Begin probing slots
Detected valid adapter in slot
Action/
Possible Failing FRU
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 306.