Seating; Replacing Tilt Module; Replacing Lifter/Tilt Module - Invacare Kite Series Service Manual

Invacare® Kite Series
4. Loosen screw (6).
5. Remove screw. Pay attention to distance washer (4) and distance tube (3).
6. Replace lamp bracket (1).
Installing Front Lamp Holder
1. Install parts in reverse order.
2. Test all functions.

6.13 Seating

This chapter deals with the replacement of interface components between the base of the mobility device and the
corresponding seating system.
For detailed instructions on the seating system, see the service manual of the corresponding seating system.

6.13.1 Replacing Tilt Module

WARNING!
Risk of Crushing
The seat/seat support is very heavy. Risk of injury to hands and feet.
– Use proper lifting techniques
• 10 mm Allen wrench
• 13 mm open-ended wrench
• 24 mm open-ended wrench
• 24 mm box wrench
• Side cutting pliers
• Tie wraps
1. Remove legrests.
2. If possible, tilt seat back as far as it will go.
3. Turn off electronics on remote.
4. Remove rear and middle shrouds. See 6.6 Shrouds, page 21.
5. Take exact note of positions of all cables and sockets that they are connected to. Mark connectors and sockets or
take a photograph with a digital camera.
6. Disconnect plug of actuator to be tested from actuator module.
7. Pull actuator cable out of mobility device. If necessary, also remove tie wraps.
8. Under seat B loosen and remove four screws A.
9.
Remove lifter C from mobility device frame D and replace it.
10. Install parts in reverse order.
11. Test all functions.

6.13.2 Replacing Lifter/Tilt Module

CAUTION!
Risk of Crushing
The seat/seat support is very heavy. Risk of injury to hands and feet.
– Use proper lifting techniques.
58
Fig. 6-68
1552415-K