INSPECTION
ENGINE OIL
1. Be sure the vehicle is on level ground.
2. Warm up the engine to normal operating temper
ature and stop it.
3. Wait for five minutes.
4. Remove the oil level gauge and check the oil lev
el and condition.
5. Add or replace oil if necessary.
Note
The distance between the L and F marks on
86U02X-004
the level gauge represents 1.0 liter (1.06 US
qt, 0.88 Imp qt).
OIL PRESSURE
t. Remove the oil pressure switch.
2. Screw the SST into the pressure switch installa
tion hole.
3. Warm up the engine to'normal operating tem
perature.
4. Run the engine at 3,000 rpm, and note the gauge
reading.
Oil pressure:
343
_
44
(3.5—4.5 kg/cm2, 50—64 psi)...DOHC
(3.0—4.0 kg/cm2, 43—57 psi)...SOHC
5. If the pressure is not as specified, check for the
76G02A-005
cause, and repair if necessary.
(Refer to Troubleshooting Guide.)
ENGINE OIL
REPLACEMENT
1. Warm up the engine to the normal operating tem
perature and stop it.
2. Remove the oil filler cap and the oil pan drain plug.
3. Drain the oil into a suitable container.
Warning
Be careful when draining, the oil is very hot.
INSPECTION, ENGINE OIL
^ kpa
kPa
2
2 -5