Connecting An Optional Scsi Hard Disk Drive To The Printer; Figure 2-2 Connecting A Scsi Hard Disk Drive To The Phaser 550 - Tektronix Phaser 550 Service Manual

Connecting an optional SCSI hard disk drive to the printer

Perform this procedure if the customer has a hard disk drive available for font
storage. Otherwise, continue to the next procedure.
1. Make sure that the printer and the SCSI disk drive are turned off.
2. Attach the SCSI cable to the printer's SCSI port.
3.
Attach the other end of the SCSI cable to the SCSI drive.
4. Attach a terminator to the SCSI drive's second connector. (This is not
required if the disk drive is internally terminated.)

Figure 2-2 Connecting a SCSI hard disk drive to the Phaser 550

5.
Select the desired SCSI address (0 through 6) on the SCSI drive. The
printer's SCSI address is 7.
6. Turn on the disk drive first, and then turn on the printer.
7.
Refer to the Phaser 550 Drivers and Utilities Printing Reference for details
on formatting the SCSI disk, controlling Sys/Start job files, and using
the LaserWriter Utility to load fonts onto the disk drive.
Installing the Printer and Drivers
SCSI cable
Terminator
SCSI drive
9013-09
Service Manual 2-11
2